E-mail Notification

By default, to control status of your tasks, you need to open the program’s main window and find them in the Task View pane. For more convenience, you can receive notifications about task results via e-mail. This behavior is task-specific and needs to be enabled for each task individually. For more details, please see New Task: Pre-, Post-Operation Actions.

E-mail notifications are sent by the Server component of the software. In settings, you need to specify parameters of your mail server, sender, message template, etc.

Configuring e-mail notifications

To enable e-mail notifications, follow these steps:

  1. Check Use e-mail notification.
  2. Fill the following fields:
    • SMTP server. Mail server to use to send e-mails.
    • Connection type. Select a connection type used for your email service.
    • SSL protocol. Set up a specific SSL protocol used by your mail server.
    • From. Sender of the letter (recommended option is Handy Backup - so you can easily find it between other messages)
    • To. Target e-mail address where you want to receive the notifications
    • Subject. Subject of the letter
    • Body. Click Edit Message Body to change welcome message, signature etc.
  3. Check Use SMTP notification if your SMTP server requires authorization. Enter the required information in the User and Password fields.
  4. Click Send Test Message to test that all fields are set correctly.

In this section:

Contact Us

support@handybackup.net

sales@handybackup.net

+1 (707) 703-13-11

Essentials

Installing Standalone Version

Installing Server Version

Installing Workstation

Workstation Configuration

Registration

Quick Start

User Manual in PDF, version 7.1.2 (5.3 MB)

User Manual in PDF, version 6 (3 MB)

User Manual for v.6 (old version)

User Manual in PDF, version 7

Who uses our backup software?